How to Clean and Maintain Your LIBECO Shetland Pillow Cover
By Cutipol: The Shape of Tomorrow’s Cuisine | Official Store | Published: 2026-10-24
Category: Tips & Care
Keep your LIBECO Shetland pillow cover looking its best with these gentle washing and drying steps. Learn how to care for the linen-wool blend without shrinking or pilling.
Quick answer
Hand-wash your LIBECO Shetland pillow cover in cool water with a mild detergent, then air-dry flat to preserve the linen-wool blend. Avoid machine washing and high heat to prevent shrinkage and pilling.
Why the linen-wool blend needs special care
The LIBECO Shetland pillow cover combines linen and wool for a soft, warm texture. Linen is strong but can shrink in hot water, while wool is delicate and prone to felting with agitation. A gentle approach keeps both fibers intact and the cover looking new.
Spot cleaning vs. full wash
For small stains, spot-clean with a damp cloth and mild soap instead of washing the entire cover. This reduces wear on the fibers and preserves the finish. Only do a full wash when the cover is visibly soiled or after several months of use.
How to wash your LIBECO Shetland pillow cover step by step
- Step 1: Pre-treat stains gently: Dab any stains with a clean cloth dipped in cool water and a drop of mild detergent. Do not rub—this can push the stain deeper into the wool fibers. Always test the detergent on a hidden corner first to check for colorfastness.
- Step 2: Hand-wash in cool water: Fill a basin with cool water (below 30°C / 86°F) and add a small amount of wool-safe or mild detergent. Submerge the cover and gently squeeze the water through the fabric for 2–3 minutes. Do not wring or twist. Hot water will shrink the linen and felt the wool—stick to cool water every time.
- Step 3: Rinse thoroughly: Drain the soapy water and refill with fresh cool water. Gently press the cover to release detergent. Repeat until no suds remain. Residual detergent can attract dirt and dull the color. A second rinse is safer than leaving soap trapped in the fibers.
- Step 4: Remove excess water without wringing: Lay the cover flat on a clean, dry towel. Roll the towel up and press gently to absorb moisture. Unroll and transfer the cover to a second dry towel or drying rack. Wringing distorts the shape and damages the wool trim—never twist.
- Step 5: Air-dry flat away from heat and sun: Place the cover flat on a mesh drying rack or a dry towel in a well-ventilated area out of direct sunlight. Do not hang it, as the weight of wet wool can stretch the fabric. Do not use a dryer or radiator. Direct sunlight can fade the beige tones of the Nash cover and weaken the linen fibers.
- Step 6: Fluff and store properly: Once fully dry, gently shake the cover to restore its loft. Store it in a breathable cotton bag or on a shelf away from moisture. Avoid plastic bins that trap humidity. A cedar block in the storage area helps repel moths without chemicals.
Product details
- LIBECO Shetland - Capa de almofada: Made from a luxurious blend of linen and wool. The fabric is extremely soft and warm. Finished with a wool trim and a practical zipper. The wool trim and zipper require extra care during washing to avoid damage—gentle handling and air drying are essential.

LIBECO Shetland - Capa de almofada - LIBECO Nash - Capa de almofada: Made from 70% linen and 30% wool in a beige color. The design uses bone and beeswax tones to soften dark arabica colors. The higher linen content means this cover can handle slightly more frequent washing, but still needs cool water and air drying to prevent shrinkage.

LIBECO Nash - Capa de almofada

