SERAX Scented Candles: How to Burn Safely and Evenly
By Cutipol: The Shape of Tomorrow’s Cuisine | Official Store | Published: 2026-10-19
Category: How-to Guides
Learn how to burn your SERAX scented candles safely and evenly. Follow these simple steps to maximize fragrance, prevent tunneling, and extend the life of your candle.
Quick answer
To burn your SERAX scented candle safely and evenly, always trim the wick to 1/4 inch before lighting, let the wax pool reach the edges on the first burn, and never leave it unattended.
Why even burning matters for SERAX candles
SERAX scented candles, like the Vela Burning Wood and Charred Santal, are hand-poured with a soy wax and paraffin blend. If you don't let the wax melt evenly across the surface on the first burn, you risk tunneling—where wax builds up along the sides and the wick burns down a narrow hole. This wastes wax and reduces the fragrance throw. A full melt pool on the first burn (and subsequent burns) ensures you get the full scent experience and maximum burn time.
How to burn your SERAX candle safely and evenly
- Trim the wick to 1/4 inch before each burn: Use a wick trimmer or scissors to cut the wick to about 1/4 inch (6 mm). This prevents a large, smoky flame and reduces soot. A trimmed wick also helps the wax pool more evenly. Never light a wick longer than 1/2 inch—it will mushroom and create excess smoke.
- Burn until the wax pool reaches the edges: On the first burn, let the candle stay lit until the melted wax reaches the sides of the container. For a medium-sized SERAX candle, this usually takes 2–4 hours. Subsequent burns should also last long enough to remelt the full surface. If you extinguish before the pool reaches the edges, a tunnel will form and the candle will never burn evenly.
- Keep the candle away from drafts and never leave unattended: Place the candle on a stable, heat-resistant surface away from open windows, fans, or air vents. Drafts cause uneven burning, rapid sooting, and can blow the flame sideways. Always extinguish before leaving the room or going to sleep. A flickering flame is a sign of a draft—move the candle to a still spot immediately.
- Extinguish safely and recenter the wick: Use a candle snuffer or gently blow out the flame. While the wax is still liquid, use a wick dipper or a toothpick to gently push the wick back to the center. This ensures the next burn stays even and the container stays clean. Do not blow out a candle if wax is splattering—use a snuffer to avoid hot wax spills.
- Stop burning when 1/2 inch of wax remains: Once the wax level drops to about 1/2 inch (1.25 cm) from the bottom, discard the remaining wax. Burning past this point can overheat the glass or metal vessel and cause cracking or fire hazard. A candle that burns too low may also release more soot and lose its fragrance strength.
Products mentioned
- SERAX Scented Candles - Vela Burning Wood cinzenta M: Hand-poured with a soy wax and paraffin mix, featuring essential oils of pine, cedar, and moss. The natural wax blend requires a longer first burn to create an even pool, so the woody fragrance diffuses fully.
SERAX Scented Candles - Vela Burning Wood cinzenta M - SERAX Scented Candles - Candle Charred Santal gold M: Features a rich blend of cardamom, cedarwood, and white musk, hand-poured in a gold-toned vessel. The gold vessel retains heat well, so letting the wax pool fully prevents uneven melting and keeps the minimalist design looking clean.
SERAX Scented Candles - Candle Charred Santal gold M
